Re: [squid-users] Can't get transparent to work with squid and RH7.2

See the Squid FAQ on how to install WCCP. You are still missing some
components (WCCP support in the kernel).

Regards
Henrik

On Monday 01 April 2002 23:50, Brad Groshok wrote:
> Hi All:
>
> Having problems getting transparent proxy to work with
> Squid 2.5pre4 on a RH7.2 system with wccp
>
> Think I have squid setup properly
> from squid.conf:
>
> http_port 3128
> httpd_accel_host virtual
> httpd_accel_port 80
> httpd_accel_with_proxy on
> httpd_accel_uses_host_header on
>
> squid will answer if I set IE to port 3128, and surf around
>
> On my cisco I have:
>
> ip wccp version 1
> ip wccp web-cache redirect-list cache
>
> ip access-list extended cache
> deny tcp host 216.240.0.25 any
> permit tcp any any eq www
>
> my fastether port out to our upstream:
>
> ip wccp web-cache redirect out
>
> Router sees cache box (from sh ip wccp)
>
> Global WCCP information:
> Router information:
> Router Identifier: 216.240.0.250
> Protocol Version: 1.0
>
> Service Identifier: web-cache
> Number of Cache Engines: 1
> Number of routers: 1
> Total Packets Redirected: 4300
> Redirect access-list: cache
> Total Packets Denied Redirect: 0
> Total Packets Unassigned: 0
> Group access-list: -none-
> Total Messages Denied to Group: 0
> Total Authentication failures: 0
>
> On my RH7.2 box: (generic install)
> I (think) I have disabled ipchains and enabled iptables
>
> chkconfig --level 2345 ipchains off
> chkconfig --level 2345 iptables on
> and rebooted
>
> ran:
> iptables -t nat -A PREROUTING -i eth0 -p tcp --dport 80 -j REDIRECT
> --to-port 3128
> to do the port forwarding.
>
> <disclaimer>
> I not a RH guy!
> </disclaimer>
>
>
>
> With all that done, on my router I see Total Packets Redirected
> increasing but never see anything in the squid access.log.
>
> Any/all help greatly appreciated.

-- 
MARA Systems AB, Giving you basic free Squid support
Customized solutions, packaged solutions and priority support
available on request