Re: [squid-users] compilation failed on HPUX 11.00

Hi there,

I also had problems compiling Squid on HPUX 11.00 with HP's
compiler. I used GNU's make which worked. However, when I tried
to compile gcc, I failed and in the end I downloaded a precompiled
binary package from the link below in depot format.

http://hpux.cs.utah.edu/hppd/hpux/Gnu/make-3.79.1/

After this, though there were a few warnings (these
seemed to not have affected Squid), it worked.

Marius Etsebeth

Henrik Nordstrom wrote:
>
> There was no attachments, but it is known that the HP make program do
> not like Squid. Try compiling using GNU make.
>
> It is a bit too early to tell if GCC-3 likes Squid, you you are welcome
> to try if you like. But if you are running HP-PA and have the HP
> compiler I would go for the HP compiler as it knows HP-PA a lot better
> than any other compiler.
>
> Regards
> Henrik Nordstr�m
> Squid Developer
>
> Bal Biyo wrote:
> >
> > Hi,
> >
> > We failed compiling squid-2.4 using gcc 3.0.4 on
> > HPUX 11.00 with March 2001 General patch.
> > Additionally, we also installed binutils 2.11.2 for
> > the compiler dependencies. Then, tried HP
> > ANSI/Ccompilers and we also failed. Is there anyone
> > can give me a hints whywe failed the compilation?
> > Attached is config.log and logs during make all.
> >
> > We will highly apreciate your immediate response.
> >
> > Regards,
> > Bal Biyo
> > Nexus Technologies, Inc.
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! Movies - coverage of the 74th Academy Awards�
> > http://movies.yahoo.com/
Received on Tue Apr 02 2002 - 01:43:04 MST