m�n 2003-05-26 klockan 12.00 skrev Stoll, Simon:
> I applied the V2 patches from visolve.com, but the squid.conf doesn's
> seem to understand the v2 commands. Any help would be higly
> appreciated.
Did you enable support for WCCPv2 when you built your Squid binary from
these patched sources?
Also, do not forget to run "make distclean" after patching Squid if you
have previously built Squid in the same source tree.
Regards
Henrik
-- Donations welcome if you consider my Free Squid support helpful. https://www.paypal.com/xclick/business=hno%40squid-cache.org Please consult the Squid FAQ and other available documentation before asking Squid questions, and use the squid-users mailing-list when no answer can be found. Private support questions is only answered for a fee or as part of a commercial Squid support contract. If you need commercial Squid support or cost effective Squid and firewall appliances please refer to MARA Systems AB, Sweden http://www.marasystems.com/, [email protected]Received on Mon May 26 2003 - 04:15:39 MDT
This archive was generated by hypermail pre-2.1.9 : Tue Dec 09 2003 - 17:17:02 MST