[squid-users] error transparent squid.2.6.stable1 with wccpv2 and tproxy

Hi,
I just install squid.2.6.stable1, kernel 2.6.15.7 with cttproxy
It work good when running transparent & wccpv2 web-cache mode

But when I addding wccp dynamic service for IP-Spoof, I get an error :

2006/07/11 08:00:37| tproxy ip=x.x.x.x,0x7a0989ca,port=0 ERROR ASSIGN

#part of my squid.conf :
http_port 3128 transparent tproxy vhost vport=80
always_direct allow all
wccp2_router x.x.x.x
wccp_version 4
wccp2_forwarding_method 1
wccp2_return_method 1
wccp2_service standard 0
wccp2_service dynamic 90
wccp2_service_info 90 protocol=tcp flags=src_ip_hash priority=1 ports=80

#part of my cisco run:
ip wccp web-cache redirect-list 155
ip wccp 90 redirect-list 156
int fasteth0 >ip wccp web-cache redirect out
int fasteth1 >ip wccp 90 redirect out

#my iptables at linux:
Chain PREROUTING (policy ACCEPT 262 packets, 18290 bytes)
 pkts bytes target prot opt in out source
destination
  112 6710 REDIRECT tcp -- gre0 any anywhere anywhere
tcp dpt:http redir ports 3128

#my sysctl:
[root@tproxy sbin]# sysctl -a | grep rp.filter
net.ipv4.conf.gre0.arp_filter = 0
net.ipv4.conf.gre0.rp_filter = 0
net.ipv4.conf.eth0.arp_filter = 0
net.ipv4.conf.eth0.rp_filter = 0
net.ipv4.conf.default.arp_filter = 0
net.ipv4.conf.default.rp_filter = 0
net.ipv4.conf.all.arp_filter = 0
net.ipv4.conf.all.rp_filter = 0
net.ipv4.conf.lo.arp_filter = 0
net.ipv4.conf.lo.rp_filter = 0

regards,
Tino
Received on Mon Jul 10 2006 - 20:28:09 MDT